One of the most common frustrations when expanding a low-voltage outdoor lighting scheme is getting everything to switch on together. If your sensor and transformers aren't properly linked, you end up with zones that don't respond in sync — or worse, a tangle of incompatible connections that stall the whole installation.
In low-voltage systems like In-Lite's, the wiring architecture matters as much as the fixtures themselves. A splitter — sometimes called a Y-connector — takes a single input signal or power feed and divides it into two outputs, allowing multiple transformers or fixtures to share one control point. Done right, it keeps your lighting plan coherent and your installation clean.
The In-Lite SPLITTER is a compact, Y-shaped cable connector designed specifically for the In-Lite low-voltage outdoor lighting ecosystem. It allows a single light sensor to control multiple transformers simultaneously, ensuring your entire lighting plan activates at the same time. It can also be used to connect several fixtures to a single EASY-LOCK connector, simplifying multi-point installations. The tool-free, push-fit connection mechanism means no specialist tools are required on site.
Built from a moulded, weather-resistant polymer with a matte black finish, the SPLITTER has a streamlined, unobtrusive form that sits discreetly within a landscape or architectural setting. Its compact Y-profile is designed to be concealed easily, whether routed above or below ground.
The SPLITTER is suitable for use both above and below ground within the In-Lite system. Its three connection points — one input and two outputs — feature recessed sockets with metallic contact pins, consistent with In-Lite's plug-and-play low-voltage cable standard. No additional tools or crimping equipment are required for installation.
At Lightsource Mallorca, we stock In-Lite system accessories alongside the fixtures themselves because outdoor lighting is only as reliable as its infrastructure. Specifying the right connectors, sensors, and transformers from the outset avoids costly on-site revisions. Whether you're designing a complete garden lighting scheme or expanding an existing In-Lite installation, we can help you map out the full system — fixtures, drivers, and connections — before anything goes in the ground.
